!"#$!%&'$#()'$(*("+&#
Turbosmart Pty Limited P.O.Box 264 Croydon, NSW, 2132 Australia ABN: 69 081 069 794
IMPORTANT)NOTES)ON)FITTING)YOUR)FPR)FUEL)RAIL)ADAPTER)
)
WARNING! Turbosmart recommends that your FPR Fuel rail adapter is fitted by an appropriately qualified technician. Turbosmart accepts no
responsibility whatsoever for incorrect installation of this product which is potentially hazardous and can cause serious engine damage or
personal injury. IMPORTANT! Ensure there are no leaks in your fuel system after the FPR fuel rail adapter installation.
)
CONTENTS)
Please check that the following items have been supplied.
Seals fuel rail adapter to fuel rail
Seals fuel rail adapter to fuel rail
1. Remove retaining clip with pliers. Remove existing regulator by
twisting while pulling up.
2. Push the fuel rail adapter into the fuel rail and replace the retaining
clip.
3. Connect the outlet port of the adapter to the FPR fuel inlet port.
Connect the return port of the adapter to the FPR fuel outlet port.
4. Your FPR should be connected to the fuel rail adapter as shown
below:
NOTE – PLEASE READ ATTACHED TERMS AND CONDITIONS.
Subject to the attached terms and conditions:
Warranty
Turbosmart warrants its products to be free from faults or defects for the life of the product. *
* Subject to Turbosmart trading terms and conditions
Warning!
Incorrect use of this product may result in damage to your vehicle. Failure to observe any notes or recommendations may result in incorrect use of this product. This product is intended for use in off-road
racing only. Turbosmart will accept no responsibility for the incorrect installation or use of this product.
Disclaimer!
Turbosmart will not be held responsible for any damage caused to property or person, directly or indirectly related to the use of any Turbosmart products.
(Hose fittings not supplied)
Pull fuel pressure
regulator up
Comments to this Manuals