------------------------------------------------------------------------------------------------------------------------
IMPORTANT NOTES:
• Please thoroughly read and understand these instructions before commencing this installation.
• The thread on the cap for the vacuum source is AN#3. The standard swivel nipple can be changed to a AN#3 fitting if desired.
RECOMMENDATIONS
• Turbosmart recommends that your Blow off valve (BOV) is fitted and adjusted by an appropriately qualified technician
• Turbosmart recommends that a boost gauge be permanently fitted to the vehicle
------------------------------------------------------------------------------------------------------------------------
HOW TO INSTALL YOUR BOV
Please check that the following items have been provided in your EVO Dual port kit.
Model Specific blow off valve
To blank off a port to convert the BOV to full atmospheric or plumb back
To secure the vacuum lines to the BOV and the engine
400mm of 5mm Silicone vacuum line
To connect vacuum source to the BOV
1) Installation on a EVO (Diagrams are from a Mitsubishi Lancer EVO X)
1) Remove the two hose clamps holding the standard BOV to the piping
2) Remove the piping and vacuum line off the standard BOV
Product Name: EVO Dual port
Product Description: Fits Lancer EVO VII – X
(7 - 10)
Product Number: TS-0205-20
Comments to this Manuals