SKYLINE R32 GTS-T BLOW-OFF VALVE ADAPTOR INSTRUCTIONS
Head Office: Turbosmart Pty Limited, PO Box 264 Croydon, NSW, 2132 Australia Ph: +61(2) 9798 2866 Fax: +61 (2) 9798 2826 Email: info@turbosmart.com.au
USA Office:
Turbosmart USA, 1185 Park Center Drive, Suite Q, Vista CA 92081 USA Ph: (760) 727 7610 Fax: (760) 727 7963 Email: sale[email protected]
IMPORTANT NOTES ON FITTING YOUR SKYLINE R32 BOV ADAPTOR
Turbosmart recommends that your Blow Off Valve (BOV) and Adaptor kit is fitted by an appropriately qualified technician.
ADAPTOR KIT CONTENTS
Please check that the following items have been provided in your Skyline R32 Adaptor Kit.
Designed to fit your R32 Skyline crossover pipe
Blanks off the factory plumb back fitting
Seals the R32 Adaptor to the crossover pipe
400mm Silicon hose assembly
Connects the factory vacuum/boost source to the Turbosmart BOV
Secures the 6mm end of the Silicon hose assembly over the factory vacuum source
Secures the 5mm end of the Silicon hose assembly over the Turbosmart BOV
Note: This Skyline R32 Adaptor readily accepts the following Turbosmart BOVs:
Blow-off Valve - Vee Port
Blow-off Valve - Supersonic
Blow-off Valve - Megasonic
Blow-off Valve - Plumb Back **
Blow-off Valve - Dual Port **
** Plumb back kit is required to connect Plumb Back and Dual Port fittings back to the intake, part # FG-ADM-R32PBK
FIT TING YOUR BOV SKYLINE R32 ADAPTOR
Note: Please thoroughly read and understand both these instructions and the fitting instructions supplied with your
BOV before commencing this installation.
Step 1. Locate the factory BOV.
Step 2. Remove the vacuum/boost hose and plumb
back hose from the factory BOV and the fittings they
are connected to. Loosen the two factory bolts securing
the factory BOV using a 12mm socket.
Step 3. Remove the factory BOV and factory gasket.
Step 4. Install one end of the Silicon hose assembly to
the factory vacuum source. Secure the Silicon hose
with the 6mm spring clamp supplied.
Remove vacuum/
boost hose
Comments to this Manuals