Turbosmart BOOST CONTROLLERS - Boost Tee User Manual download pdf

------------------------------------------------------------------------------------------------------------------------

ABOUT THIS PRODUCT

Thank you for purchasing your new Turbosmart Boost Tee. This new model now has some great new features. These include:

• 2 ramp rates of boost to give you the option of a fast rise in boost or a slightly tame rise for more sensitive setups.

• A wider boost adjustment range for wastegates with low spring base pressures.

• A new mounting bracket to make it easier to mount.

IMPORTANT NOTES ON YOUR BOOST CONTROLLER

• Use only silicone hose that is the correct size and pressure rating for your application when fitting your boost controller – other

hoses will be effected by heat and will eventually crack or split which could cause excessive boost pressure and engine damage

• Ensure that all plumbing is secured with clamps

• Your boost controller should be mounted at least 100mm from any heat source

• A Turbosmart Fuel Cut Defender may need to be used in conjunction with your boost controller – refer to www.turbosmart.com.au

• The boost dial has a left handed thread, be sure not to over tighten as this will damage the boost controller

RECOMMENDATIONS

• Turbosmart recommends that the Air Fuel ratio is checked once boost pressure is set

• Turbosmart recommends that boost pressure is set using a Dynamometer and not on the street

• Turbosmart recommends that a accurate boost gauge be permanently fitted to the vehicle

• Turbosmart recommends that your boost controller is fitted and adjusted by an appropriately qualified technician

------------------------------------------------------------------------------------------------------------------------

HOW TO INSTALL YOUR BOOST CONTROLLER

TOOLS REQUIRED

General mechanic tools

1) INTERNAL WASTEGATE SETUP

• Allow the engine to cool down before installing your boost controller

• Locate the pressure source port and the wastegate actuator port on the turbocharger assembly (refer drawing 1)

• Remove the factory boost control solenoid if fitted from the boost pressure supply port while leaving the solenoid connected to the

ECU

• Install your boost controller in the wastegate pressure line with the wastegate arrow pointing towards the wastegate actuator

• If your wastegate actuator has additional ports, these will need to be blocked

• Secure all silicone hose ends with hose clamps

• Mount your boost controller bracket onto the vehicle, then attach the boost controller onto the bracket with the supplied screws

• Make sure the boost dial is turned completely anti-clockwise before making adjustments.

Product Name: BOOST TEE

Product Description: Manual Boost Controller

Product Number: TS-0101-1001

Wastegate actuator port

Boost Tee

Pressure source port

(Located before the

throttle body)

Compressor

Hose clamps

Boost dial

Wastegate Arrow

Drawing 1

1 2 3 4

BOOST SPIKING 3
Happy motoring! 4

Summary of Contents

Page 1

1 ------------------------------------------------------------------------------------------------------------------------ ABOUT THIS PRODUCT Thank

Page 2

2 HOW TO INSTALL YOUR BOOST CONTROLLER cont. 2) EXTERNAL WASTEGATE SETUP • Allow the engine to cool down before installing your boost controller

Page 3 - BOOST SPIKING

3 SETTING BOOST PRESSURE IMPORTANT NOTES ON BOOST PRESSURE ADJUSTMENT • Adjustment to your boost controller is made by rotating the Boost Dial

Page 4 - Happy motoring!

4 DO NOT USE ANY TURBOSMART PRODUCT UNTIL YOU HAVE CAREFULLY READ AND UNDERSTOOD THE FOLLOWING AGREEMENT. Please call if you have any question

Comments to this Manuals

No comments

Turbosmart BOOST CONTROLLERS - Boost Tee User Manual

Browse online or download User Manual for For the car Turbosmart BOOST CONTROLLERS - Boost Tee. Turbosmart BOOST CONTROLLERS - Boost Tee User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Turbosmart BOOST CONTROLLERS - Boost Tee